Curtis 1226BL handleiding
Handleiding
Je bekijkt pagina 27 van 124
2 — INSTALLATION AND WIRING
pg. 19
Return to TOC Curtis Model 1226BL – July 2024
e belly button check function provides a 15VDC bias to the emergency reverse NC switch’s circuit.
Pin J3-4 measures the signal as an analog voltage level. e controller monitors the switch’s voltage
level to determine the circuit’s continuity. e following table describes the pin J3-4 voltage levels
that indicate the state of the emergency reverse circuit:
Voltage Condition
<3V Broken circuit
3-13V Open switch
>13-15V
The current state of the emergency reverse input will not be changed.
For example, if the current state is Off, the state will change to On only
if the voltage is increased to 15V.
>15V Closed switch
Note: If the belly button check is enabled but pins J3-4 and J3-16 are not connected, the vehicle will
not operate.
Electromagnetic Brake
If the vehicle uses an electromagnetic (EM) brake, pin J3-12 provides the EM brake driver output.
For specications on the driver, see Table 2.
e EM brake should also be connected to the Coil Supply pin (J3-10) as shown in Figure 6.
Set the EM Brake Type parameter to specify whether the vehicle system uses an EM brake, as well as
the conditions under which the controller applies the EM brake. e controller also provides a brake
holding voltage feature that reduces brake coil heating. See EM Brake Menu.
Use the EM Brake Driver Checks Enable parameter to specify whether a fault is generated if the
controller detects an open condition in the driver's wiring.
Emergency Stop Switch
To ensure operator safety, it is recommended that the vehicle include an emergency stop switch.
e switch, with an auxiliary contact, must be connected to the battery and keyswitch as shown in
Figure 6.
Mode Switch
Vehicles can include a mode switch that allows operators to choose from the 1226BL controller’s speed
modes. One mode can be congured for faster outdoor driving and the other for slower indoor driving.
If the vehicle uses a mode switch, connect the switch to pin J3-18.
e following list describes the conditions that determine the active speed mode.
• If a mode switch is not connected, mode 1 is active.
• If the mode switch is in the on position, mode 2 is active.
• If the mode switch is in the o position, mode 1 is active.
Note: For information on conguring speed modes, see Mode 1 and Mode 2 Menus.
Bekijk gratis de handleiding van Curtis 1226BL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Curtis |
| Model | 1226BL |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15971 MB |
