Cigweld Transmig 4RT handleiding
Handleiding
Je bekijkt pagina 35 van 62
INSTALLATION/SETUP TRANSMIG 4RT
Manual 0-5245 3-19 INSTALLATION/SETUP
Front View 4RT
Rear View 4RT
Control Cable
Welding Power Cable
from Wire Feeder
Work Lead
+
_
Art# A-11280
Transmig 350i,450i,550i
10 Pin
Control Socket
Figure 3-9: Setup for 4RT Wirefeeder with Gasless MIG Wire
WARNING
Before connecting the work clamp to the work make sure the mains power supply is switched off.
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug being fused in the
terminal.
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the Welding
Power Source.
NOTE
Depending on the type of wire you will be using the MIG Torch polarity may need to be switched. Follow
the wire manufacturers recommendation.
NOTE
Spool hub and feed plate set up and operation are similar to the 250i which can be reviewed later in this
section starting at 3.12.
Bekijk gratis de handleiding van Cigweld Transmig 4RT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cigweld |
| Model | Transmig 4RT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8070 MB |
