Cigweld Transmig 4RT handleiding
Handleiding
Je bekijkt pagina 33 van 62
INSTALLATION/SETUP TRANSMIG 4RT
Manual 0-5245 3-17 INSTALLATION/SETUP
Connection to Transmig 350i,450i,550i
The Transmig 350i, 450i and 550i are supplied with a Tweco air-cooled MIG Torch that can be used with the 4RT Wire
Feeder. The Tweco MIG Torch is designed with an ergonomic handle and fewer parts to cause performance problems.
The Tweco MIG Torch uses standard readily available Tweco Fusion consumable parts.
When using a Gas Shielded wire with the 4RT Wire Feeder, you need to have an external gas source attached to the 4RT.
For most Gas Shielded wire, connect the Work Lead to the negative - terminal on the front of the Transmig Power
Source and connect the Welding Power Cable from the back of the 4RT to the positive + terminal on the front of the
Transmig Power Source. Check with wire manufacturer for recommended polarity.
The 4RT Wire Feeder requires an interconnection cable assembly to connect from the back of the 4RT to the front of
the Transmig welding power source. 2, 8 and 15M lengths are available.
Connect the MIG Torch to the front of the 4RT as you would to the front of the Transmig Power Source. See Figure
3-7 and Sub Section 3.11.
Front View 4RT
Rear View 4RT
Control Cable
Welding Power Cable
from Wire Feeder
Work Lead
Gas Hose
+
_
Art# A-11279
Transmig 350i,450i,550i
10 Pin
Control
Socket
Figure 3-7: Setup for 4RT Wirefeeder with Gas Shielded MIG Wire
WARNING
Before connecting the work clamp to the work make sure the mains power supply is switched off.
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug being fused in the
terminal.
NOTE
Depending on the type of wire you will be using the MIG Torch polarity may need to be switched. Follow
the wire manufacturers recommendation.
NOTE
Spool hub and feed plate set up and operation can be reviewed later in this Section starting at 3.12.
Bekijk gratis de handleiding van Cigweld Transmig 4RT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cigweld |
| Model | Transmig 4RT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8070 MB |
