Chief DVM27U2E handleiding
Handleiding
Je bekijkt pagina 13 van 24
Installation Instructions DVM27U Series
13
7. Slide the H-blocks together within the extrusion and attach
a magnetic 2-foot level to side of upright. (See Figure 4)
Figure 4
8. Mark mounting hole location along lower line based on
horizontal locations determined in Step 2a. (See Figure 4)
9. Level and drill a 7/32" hole at the location of the first lower
mounting hole. (See Figure 4)
10. Use 5/16 x 2 1/2" hex head lag screw (CA) and 5/16"
washer (CE) to install left upright (A) to wall at lower
mounting hole. Center the lag bolt horizontally along
mounting slot. (See Figure 4)
11. Hold mount upright and tighten upper lag bolt (CA) that was
partially installed in Step 6. (See Figure 4)
12. Determine and mark the adjacent mounting location along
the upper level line using the following formula (See Figure
5) :
• MPW [mounting pattern width] - 5.75"
(146.1mm)
Figure 5
13. Drill 7/32" mounting hole at marked location. (See Figure 5)
14. Use 5/16 x 2 1/2" hex head lag screw (CA) and 5/16"
washer (CE) to loosely install right upright (B) to wall. Center
the lag bolt horizontally along mounting slot. PARTIALLY
tighten bolt. (See Figure 6)
Figure 6
7
7/32"
8 9
(CA)
10
(CA)
11
drywall screw
holes
(CE)
Just a tip - Install a drywall screw (CC) through
one of the smaller holes in foot to prevent the
upright from "walking" in slot when tightening lag.
(See Figure 4)
MPW - 5.75[146.1]
7/32"
12 13
(CA)
(B)
14
(CE)
Bekijk gratis de handleiding van Chief DVM27U2E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Chief |
| Model | DVM27U2E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3836 MB |
