Champion DH3000 handleiding
Handleiding
Je bekijkt pagina 16 van 79
INSTALLATIONINSTALLATION
Standard Dishwashers are shipped from the factory for 3-phase
operation. To connect the dishwasher for 3-phase operation:
1. Remove the front panel and locate the main terminal block in the
lower right corner of the panel (see Fig. 11).
2. Refer to the Machine Electrical Connection Data Plate located
near the main terminal block and make sure that the incoming
power supply matches the machine's electrical requirements.
3. Connect the incoming 3-phase power as shown (see Fig. 12).
4. Re-install the lower front panel.
ELECTRICAL CONNECTIONS
NOTE
Refer to the next page for 3-phase to 1-phase eld conversion instructions.
THREE PHASE CONNECTIONS
Fig. 11 - Main Terminal Block Location
(cont. on next page)
WARNING
Electrocution or serious injury may result when working on an energized circuit.
Disconnect power at the main breaker or service disconnect switch before working on the
circuit. Lock-out or tag the breaker to indicate that work is being performed on the circuit.
CAUTION
A qualied electrician must connect the main incoming power to the dishwasher in accordance with all local
codes and regulations or in the absence of local codes in accordance with the National Electrical Code.
Minimum Wall Clearance 4” [102mm]
86”
[218cm]
Door
Removal Ht.
76¾”
[195cm]
Door Up
Ht.
33¾”
[86cm]
Load
Ht.
17¼”
[44cm]
Inside
Clearance
65¼”
[166cm]
Machine
Ht.
26⅛”
[66cm]
Incoming
Power
Fig. 12 - Three Phase Power
Connection 208-240V/60/3
THREE PHASE
POWER CONNECTION
208-240V/60/3
LINE IN
L1 L2 L3
GRD
16
Bekijk gratis de handleiding van Champion DH3000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Champion |
| Model | DH3000 |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 9847 MB |
