Champion DH3000 handleiding
Handleiding
Je bekijkt pagina 17 van 79
INSTALLATIONINSTALLATION
A standard 3-phase operation dishwasher can be converted for 1-phase
operation with the installation of a jumper wire on the main terminal and
rewiring of the wash tank and booster tank heaters.
To convert the dishwasher from 3-phase to 1-phase operation:
INSTALL MAIN TERMINAL BLOCK JUMPER WIRE
1. Disconnect all power to the machine.
2. Remove the front panel cover and locate the main terminal
block located in the lower right corner of the panel.
3. Connect the jumper wire (shipped inside) between L2 and L3
on the output side of the main terminal block (see Fig. 13).
4. Connect the 1-phase incoming power supply to L1 and L2 on
the input side of the main terminal block.
REWIRE WASH TANK HEATER ELEMENT FOR 1PH
1. Remove lower front panel.
2. Remove paper insulator and jumper bars from heater terminals.
3. Reposition jumper bars for 1PH as shown (see Fig. 14).
4. Connect the #33 wire to one element terminal as shown.
5. Connect the #34 and #35 wires to the other terminals as shown.
6. Reinstall paper insulator and the junction box cover.
REWIRE BOOSTER HEATER ELEMENT FOR 1PH
1. Remove paper insulator and jumper bars from the heater terminals.
2. Install jumper bars for 1PH as shown below.
3. Connect the #36 wire to one element terminal as shown (see Fig. 16).
4. Connect the #37 and #38 wires to the other terminals as shown.
5. Reinstall paper insulator and the booster heater element cover.
AFFIX NEW DATA PLATE ON TOP OF EXISTING
MACHINE DATA PLATE TO COMPLETE CONVERSION
(section end)
3-PHASE TO 1-PHASE CONVERSION
Fig. 13 - Single Phase Power
Connection 208-240V/60/1
SINGLE PHASE
POWER CONNECTION
208-240V/60/1
LINE IN
GRD
L1 L2
L1 L2 L3
JUMPER
NOTE
A jumper wire, additional jumper bars and a new
data plate are stowed in the literature package.
Fig. 14 - Reposition Jumper Wires for 1PH
Wash Tank Heater Element
3PH
33
34
35
L3
L2
L1
33
34
35
1PH
L3
L2
L1
Fig. 15 - Marked Booster Heater Element
CAUTION
Verify there is a paint mark on the booster heater
element before making change (see Fig. 15).
If mark does not exist, contact factory.
36
37
38
3PH
L3
L2
L1
36
37
38
1PH
L3
L2
L1
Fig. 16 - Reposition Jumper Wires
for 1PH Booster Heater Element
17
Bekijk gratis de handleiding van Champion DH3000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Champion |
| Model | DH3000 |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 9847 MB |
