Cecotec Bolero DressCode 9970 Direct Drive handleiding

Wasmachine

Cecotec

272 pagina's

PDF beschikbaar

Handleiding

/ 272

Je bekijkt pagina 85 van 272

BOLERO DRESSCODE 8970/9970/10970 DIRECT DRIVE/STEEL

ENGLISH

Site preparation

- Clean the oor and wall if necessary.

- Install the washing machine on a solid, level oor with drainage facilities rather than on

soft carpet or wooden oor.

- Do not place dirty laundry or other items on top of the appliance as this may aect normal

operation.

Warnings

Electrical connection

- Position the washing machine so that the power socket is easily accessible.

- Do not install pipes in places where temperatures drop below freezing. Pipes will freeze

and burst. In addition, temperature below zero will damage the knob and buttons.

- If you move the appliance to an environment where the temperature is below freezing,

then keep it at room temperature for several hours before operation.

Earthing

- The washing machine must be connected to an earthed socket. Should a problem occur,

the appliance can reduce the risk of electric shock. This appliance is equipped with a cable

that includes a wire and a grounding plug. The grounding plug must be inserted into an

appropriate power socket. If you are unsure whether the washing machine is properly

earthed, contact a qualied maintenance professional. If the power socket does not match

the grounding plug, do not attempt to modify it yourself.

- If the washing machine emits smoke or unusual odours, disconnect the power immediately

and contact a qualied maintenance professional.

The appliance must be connected to the water supply. Use the new water hose supplied rather

than the old one. To ensure quality, water injection tests are carried out before the washing

machine leaves the factory. Therefore, there may be water inside the drum, door seals and

door panel, which is normal.

Water inlet connection

1. The water supply pressure must be between 30 kPa and 1000 kPa.

2. Do not tighten the thread when connecting inlet hoses.

3. If the water supply pressure exceeds 1000 kPa, install a pressure regulator.

4. There are two seals in the connectors at both ends of the hose to prevent leaks.

5. Open the tap and check the connectors for leaks.

6. Check the hoses regularly, replace them if necessary.

7. Make sure that the hoses are not damaged or in contact with each other.

Connecting inlet hoses and taps

To connect inlet hoses and taps, use a standard tap as shown in Figure 7.

01339_EU01_100005_Proclean 5010 Inverter:White.indd 8501339_EU01_100005_Proclean 5010 Inverter:White.indd 85 29/1/25 9:1929/1/25 9:19

/ 272

Bekijk gratis de handleiding van Cecotec Bolero DressCode 9970 Direct Drive, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.