Carel iJW handleiding
Handleiding
Je bekijkt pagina 25 van 104
25
ENG
iJW +0300103EN rel. 1.1 - 31.03.2025
Index
5. CONFIGURATION WIZARD
The iJW controller features an advanced confi guration “wizard” that, via a guided procedure, helps users to choose a embedded
confi guration and set the main unit parameters.
The wizard can be run from the user terminal or from the Applica app; in the latter case, the controller can be confi gured via
Bluetooth™ (on models where featured) with the controller powered, or via NFC even without power connected.
5.1 Wizard from the user terminal
When fi rst started, the iJW controller shows the message “CFG” on the display, indicating that the confi guration wizard needs to
be run. On pressing the PRG key the user can decide whether or not to run the wizard, using UP and DOWN to select “yES” (run
the wizard) or “no” (skip the wizard), and confi rming by pressing PRG again. When running the wizard, one of the embedded
confi gurations on the controller can be selected (see the list of available confi gurations and corresponding connections in the
Appendix) so as to easily set all the main parameters that allow the unit to function. If deciding not to run the wizard, all the unit
parameters will need to be set from the user terminal, using the Applica app or the Applica Desktop confi guration software.
Par. Desc. Def. Min Max UOM User User term.
IS Working confi guration 0 0 IS_Max - S YES
A5
(wizard
only)
Digital input (DI2) confi guration:
0 = Not confi gured 3 = NO door switch 5 = NO remote ON/OFF
1 = NO external alarm 4 = NC door switch 6 = NC remote ON/OFF
2 = NC external alarm
0 0 6 - U YES
/P1 Confi guration of probes S1, S2, S3, S4, B5
0 = PT1000; 1 = PTC; 2 = NTC; 3 = NTC-LT; 4 = NTC-HT.
204 - S NO
The procedure for running the wizard from the user terminal is illustrated in the fi gure. To complete the confi guration, the values
of the following parameters need to be set:
IS: confi guration number;
A5: function and logic (NO/NC) of the digital input;
/P1: type of temperature probes.
The service icon on indicates that one of the wizard parameters has never been displayed; all three parameters must be dis-
played at least once in order to complete the procedure.
401 ...430
0...6
0...4
ok!
Fig. 5.a
Notice: if the procedure is not completed, the values are not saved and the next time the controller is switched on the dis-
play repeats the procedure, showing “CFG”. Only after completing the procedure or skipping the wizard will the controller show
the standard display.
Caution: the wizard can be repeated by resetting the controller to the factory values using parameter rSC; in this case,
however, all the settings made previously will be lost (unless the parameter confi guration has been saved, see the section on
Confi gurations).
Bekijk gratis de handleiding van Carel iJW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Carel |
| Model | iJW |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 14964 MB |
