Handleiding
Je bekijkt pagina 13 van 16
Instruction manual C817C Instruction manual C817C
24 25
Please keep this instruction manual for future reference
Please keep this instruction manual for future reference
BEFORE INSTALLING THE HOB
› The ceramic hob must be installed by qualied personnel or technicians. Please never conduct
the installation by yourself.
› Check the work surface is square and level, and no structural parts interfere with the
space requirements.
› Ensure the work surface is made of a heat-resistant material.
› If the hob is installed above an oven, check the oven has a built-in cooling fan.
› The installation must comply with all clearance requirements and applicable standards
and regulations.
› Ensure a suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the local wiring
rules and regulations.
› The isolating switch must be of an approved type and provide a 3mm air gap contact
separation in all poles [or in all active [phase] conductors if the local wiring rules allow for this
variation of the requirements].
› The isolating switch must be easily accessible to the customer once the hob is installed.
› Consult local building authorities and by-laws if in doubt regarding installation.
› Use heat-resistant and easy-to-clean nishes [such as ceramic tiles] for the wall surfaces.
AFTER INSTALLING THE HOB
› Ensure the power supply cable is not accessible through cupboard doors or drawers.
› Ensure there is an adequate ow of fresh air from outside the cabinetry to the base of the hob.
› If the hob is installed above a drawer or cupboard space, a thermal protection barrier is
installed below the base of the hob.
› The isolating switch must be easily accessible by the customer.
ADJUSTING THE BRACKET POSITION
Fix the hob to the work surface by screwing 4 brackets on the bottom of hob [see picture] after
installation. Adjust the bracket position to suit different worktop thickness’s.
oonn
HOB
WORK SURFACE
A
HOB
WORK SURFACE
B
BRACKET
BRACKET
Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after installation (see picture). This will
ensure the hob is properly secured to the underside of the work surface.
Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop
after installation [see picture]. This will ensure the hob is properly secured to the underside of the
work surface.
CAUTIONS:
› The ceramic hob should not be mounted next to cooling equipment, dishwashers
and rotary dryers.
› The wall and cooking zone above the work surface must withstand heat.
› To avoid any damage, the worktop sandwich layer and adhesive must be heat resistant.
BEFORE LOCATING THE FIXING BRACKETS
› The unit should be placed on a stable, smooth surface [use the packaging].
Do not apply force onto any controls protruding from the hob.
screw
A
bracket
B
screw hole
C
base
D
Bekijk gratis de handleiding van Caple C817C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Caple |
| Model | C817C |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 1219 MB |
