Handleiding
Je bekijkt pagina 12 van 16
Instruction manual C817C Instruction manual C817C
22 23
Please keep this instruction manual for future reference
Please keep this instruction manual for future reference
INSTALLATION
Cut out the work surface according to the sizes shown in the drawing. For the purpose of
installation and use, a minimum of 50mm space must be left around the hole. If installing with
xing clips, a work surface of at least 30mm should be used. Due to the limits of the xing clips, If
the work surface is less than 30mm, add a small strip of heat resistant material to the underside of
the surface. This will increase the surface depth for the clips to attach to. Please select
heat-resistant work surface material to avoid deformation caused by the heat radiation from the
hob. See below:
L [MM] W [MM] H [MM] D [MM] A [MM] B [MM] X [MM]
590 520 51 47 562 482 50 [min]
WARNING:
Always ensure the hob is well ventilated and the air inlet and outlet are not blocked. Ensure the
ceramic hob is in good working order. See below:
A [MM] B [MM] C [MM] D E
600 25 [min] 20 [min] Air intake Air exit [5mm]
Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after installation (see picture). This will
ensure the hob is properly secured to the underside of the work surface.
NOTE:
For safety, the distance between the hob and the cupboard above should be at least 600mm.
WARNING: ENSURE ADEQUATE VENTILATION
Make sure the ceramic hob is well ventilated and that air inlet and outlet are not blocked. In order
to avoid accidentally touching with the overheating bottom of the hob, or getting an unexpected
electric shock during working, it is necessary to put a wooden insert, xed by screws, at a
minimum distance of 25mm from the bottom of the hob. Follow the requirements below.
WARNING: Ensure adequate ventilation
Make sure the ceramic hob is well ventilated and that air inlet and outlet are not blocked. In order to avoid accidentally touching
with the overheating bottom of the hob, or getting an unexpected electric shock during working, it is necessary to put a wooden
insert, fixed by screws, at a minimum distance of 25mm from the bottom of the hob. Follow the requirements below.
Min. 25mm
Max. 5mm Max. 5mm
There are ventilation holes around the outside of the hob. YOU MUST ensure these holes
are not blocked by the worktop when you place the hob in position.
The rear wall, adjacent and surrounding surfaces must be able to withstand an
temperature of 90°C.
Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after installation (see picture). This will
ensure the hob is properly secured to the underside of the work surface.
Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after installation (see picture). This will
ensure the hob is properly secured to the underside of the work surface.
Bekijk gratis de handleiding van Caple C817C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Caple |
| Model | C817C |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 1219 MB |
