Cambium Networks cnReach N500 handleiding

Niet gecategoriseerd

Cambium Networks

253 pagina's

PDF beschikbaar

Handleiding

/ 253

Je bekijkt pagina 66 van 253

cnReach N500 User Guide System Configuration

phn-4980_001v004 August 2019)

2-33

The Diagnostic Threshold is the level at which the user wishes to detect noise.

Auto-Configuration Mode

In Auto-configuration mode, EPs automatically retrieve many of the air interface parameters from the

Access Point. In auto-configuration mode, APs send information about the air interface in the broadcast

beacon. Using auto-configuration mode can dramatically reduce the complexity of configurating end

points. This makes for fewer errors in configuration. More importantly, it is easier to make changes to

the interface settings because the changes are only required to be made at the AP and not at every

single EP.

An example: the administrator wishes to add a higher modulation mode or change the network radius

or modify the max payload bytes to alter the uplink/downlink capacity of a sector.

With full configuration mode, the change must be made on each EP either over the air or by visiting the

sites. Then the AP is changed and the administrator confirms that all settings were made correctly and

the network is operational again. If a setting was made incorrectly on an EP, it may be necessary to roll

a truck to that EP to recover it with the correct setting.

With auto-configuration mode, the change is only made once at the AP. All EP’s then automatically

update their configuration and re-connect. If a setting is made that prevents an EP from re-connecting

automatically, the administrator can simply revert the setting on the AP and the network returns to its

previous operation with no site visits necessary.

Auto-Configuration is enabled on the Radio/Network Settings Page.

Configuration

Auto-Configuration is enabled on the Radio/Network Settings Page. All AP’s and EP’s in a sector must

have the same auto-configuration setting. Settings are one of:

Off: full configuration mode

On, Fast Mode: recommended for new installations

Off, Compatibility Mode: recommended for migrating sectors to auto-configuration

Select On, Fast Mode and then hit save to apply the settings to both the Radio/Network Settings page

and the Radio/RF Settings Page

In Unlicensed 900 MHz operation, the follow parameters are auto-configured and no longer have to be

set at the EP as they are picked up automatically from the AP.

– Network type

– Roaming

– Network Radius

– Beacon Interval

– AP Repeat

– MMS

– Max Payload Bytes

/ 253

Bekijk gratis de handleiding van Cambium Networks cnReach N500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.