Cambium Networks cnReach N500 Handleiding (253 Pagina's)

Handleiding

/ 253

Je bekijkt pagina 67 van 253

cnReach N500 User Guide System Configuration

phn-4980_001v004 August 2019)

2-34

– Dynamic Payload

– Hop Pattern

– End Point Transmit Rates

The following must still be set at both AP and EP:

– Auto-configure mode

– Network Role

– Network Address

– Device ID

– Link-with Device ID

– Protocol

– Frequencies

– Transmit Power

– Error Correction

Note the fields removed from the settings pages below:

Notes on Auto-configure

– After making a change to any of these parameters, the AP will broadcast an auto-cfg

beacon periodically to all EP’s. When an EP receives this auto-cfg beacon, it will adjust

its parameters and restart the radio interface. Depending on the change of the

configuration parameters, it could take up to twenty(20) minutes for the EPs to

reconnect to the AP.

– When an EP in auto-configuration mode first powers up or after a link is lost, the EP will

be in ‘search’ mode waiting for the period auto-cfg packet. When if receives the packet

it will set all values based on this packet.

– When encryption is enabled on a link, the encryption keys must also match as the auto-

configure beacons are also encrypted.

– Auto-configure beacons are sent in every idle beacon. In a very busy network (with no

idle frames), the AP will insert additional beacons to ensure they get through. So in a

non fully-loaded network, there is no capacity impact.

/ 253

Bekijk gratis de handleiding van Cambium Networks cnReach N500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.