Cambium Networks cnMatrix EX2010-P handleiding

Niet gecategoriseerd

Cambium Networks

320 pagina's

PDF beschikbaar

Handleiding

/ 320

Je bekijkt pagina 164 van 320

L2 Features 164

cnMatrix(config-if)# switchport [customer-vlan <integer(1-4094)>] service-vlan <vlan_id>

cnMatrix(config-if)# no switchport [customer-vlan <integer(1-4094)>] [service-vlan]

If customer-vlan is not specified, the service-vlan will be applied to all incoming packets, regardless of C-

VLAN:

cnMatrix(config-if)# switchport service-vlan <vlan_id>

cnMatrix(config-if)# no switchport service-vlan <vlan_id>

cnMatrix(config-if)# switchport [customer-vlan %d] svlan-prio {<0-7> | none}

Specifies which dot1p priority to be used in the S-TAG: either a fixed user-set value, or none. If customer-

vlan is not specified, the S-VLAN-prio will be applied to all incoming packets, regardless of C-VLAN.

cnMatrix(config-if)# switchport customer-vlan pvid <vlan_id>

Specifies which C-VID value to use for untagged packets received on the customer-edge port. The

specified VLAN Id must be already configured on the port as a customer-vlan.

cnMatrix(config-if)# service-vlan <svlan> pvid <pvid>

If C-untagged packets are received on the provider port, a C-TAG needs to be added. The PVID

configured here will be the VLAN id from the C-TAG. This command is configured on the customer port,

but the value set here is applied on all network provider ports from the S-VLAN.

cnMatrix(config-if)# service-vlan <svlan> def-user-priority <value>

If C-untagged packets are received on the provider port, a C-VLAN needs to be added. The default

priority value configured here will be the dot1p used in the C-TAG. This command is configured on the

customer port, but the value set here is applied on all network provider ports from the S-VLAN.

On provider ports:

cnMatrix(config-if)# switchport egress ether-type {x8100 | x88a8 | x9100}

Specifies which TPID to be used in the S-TAG of the frames egressing on this port.

cnMatrix(config-if)# no switchport egress ether-type

Defaults which TPID to be used in the S-TAG of the frames egressing on this port.

cnMatrix(config-if)# switchport ingress ether-type {x8100 | x88a8 | x9100}

Specifies which TPID to use to determine the S-TAG of the frames ingressing on this port.

cnMatrix(config-if)# no switchport ingress ether-type

Defaults the TPID used to determine the S-TAG of the frames ingressing on this port.

cnMatrix# show provider-bridge port config

Provider Bridge Port configuration table

Port Gi0/1

Port Type : Customer-edge Port

Dot1x Protocol Tunnel Status : Peer

LACP Protocol Tunnel Status : Peer

Spanning Tree Tunnel Status : Discard

LLDP Protocol Tunnel Status : Peer

Service VLAN Classification : Customer-VLAN

/ 320

Bekijk gratis de handleiding van Cambium Networks cnMatrix EX2010-P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.