Bushnell R5 handleiding
Handleiding
Je bekijkt pagina 6 van 33
6
Click to return to the Table of Contents.
FINAL SIGHTING-IN
WARNING: SINCE THIS PROCEDURE INVOLVES LIVE FIRE, IT SHOULD BE DONE AT AN APPROVED RANGE OR
OTHER SAFE AREA. CHECK BORE FOR OBSTRUCTIONS. AN OBSTRUCTED BORE MAY CAUSE INJURY TO YOU
AND OTHERS NEARBY. EYE AND EAR PROTECTION IS RECOMMENDED.
1. From a steady rest position, fire two or three rounds at a 50-100 yard target. Note the impact of the bullet on the target and
adjust the windage and elevation dials as needed.
2. To move the bullet’s point-of-impact relative to the reticle’s point-of-aim, turn the windage and/or elevation adjustments in
the direction on the dials that corresponds to the direction that you want the point-of-impact to change to on the target (for
example, if test shots are hitting low, adjust the elevation direction “up”). The adjustments on your riflescope model are marked
in MOA (minutes of arc), and the point of impact at 100 yards will change by 1/4 MOA or approximately 1/4 in. for each click of
the windage or elevation adjustment. One full revolution of the adjustment=15 MOA.
3. When the impact on the intial target distance is satisfactory, switch to a target set at the desired distance for final zeroing (50
yards is recommended for rimfire applications and 100 yards for centerfire). Set the magnification to the desired power on
variable power models.
RESETTING THE TURRET KNOBS
1. While holding a turret knob steady with your free hand (to avoid accidental adjustment),
use a coin, key or flathead driver to remove the turret cap-screw found on top of the turret
knob.
2. Remove the turret knob and return it to the inner turret with the “zero” mark on the knob
lining up with the vertical index line on the inner turret body.
3. Return the turret knob screw to the top of the knob and tighten it down, making sure to
steady the turret knob with your free hand so the turret knob does not turn while tightening
the screw.
4. Repeat for the other turret knob.
ILLUMINATED MULTI-X RETICLE
Dimensions in MOA
Turret knob
Turret screw
Index line
60.00°
0.75
0.50
0.25
4.00
1.00
DETAIL
A
SCALE
5 : 1
Detail A
Scale 5:1
Bekijk gratis de handleiding van Bushnell R5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bushnell |
| Model | R5 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7861 MB |
