Bunn WEQ-10 System handleiding
Handleiding
Je bekijkt pagina 11 van 20
INSTALLATION (CONTINUED)
MODULAR DESIGN
The design allows for adaptation to any appli-
cation using multiple manifold assemblies and
a large variety of ttings and adapters.
1. Determine system mounting location and
mark water pipe section to be removed.
Carefully cut and remove the piping.
2. Install the appropriate adapter (not includ-
ed) on to the inlet section of water pipe to
mate with system inlet tting.
3. Connect system inlet tting to adapter on
inlet section of the water pipe. Use Tef-
lon™ tape on threaded connection.
4. Slide the manifold assembly on the system
tting. Slightly rotate the tting for the key
to line up with the manifold and lock in.
5. Secure the tting and manifold assembly
together by installing the yellow U Clips in
the slots (Figure 2).
6. With the manifold assembly in level posi-
tion, mark four mounting holes on the wall
at each corner of the manifold.
7. Remove the manifold assembly from the
tting and drill four pilot holes for the
mounting bolts.
8. Re-attach manifold assembly to tting and
install yellow U Clips to secure in place.
9. Fasten the manifold assembly to the wall
using four bolts (not included).
10. Install plug ttings on the top left and bot-
tom right of the manifold assembly, using
two yellow U Clips to lock them in place
(Figure 3).
11. Install outlet tting to top right of the
manifold assembly (gauge optional) and
secure with a yellow U Clip.
FIGURE 2. SECURE MANIFOLD
FIGURE 3. INSTALL PLUG FITTINGS
12. Using appropriate adapters (not included),
connect the manifold outlet to water pipe.
13. With the cartridge label facing slightly to
the left, insert the cartridge into the head
assembly and turn to the right quarter turn
until fully seated.
56000.0500 B
7/21 © 2021 Bunn-O-Matic Corporation
Page 11
www.bunn.com
803426
Bekijk gratis de handleiding van Bunn WEQ-10 System, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bunn |
| Model | WEQ-10 System |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5997 MB |
