Handleiding
Je bekijkt pagina 21 van 52
Cupboard mounting installation:
1.
Drill a 130mm diameter and four
3.5mm
diameter hole as below
picture.
ATTENTION: If your cooker hood
works
at circulating-air mode, it is
not necessary
to drill 130mm
diameter hole.
2.
Use the 4 screws to fix the cooker
hood
to a kitchen cupboard .Check
that your
fixings are correctly
located, by temporarily
fitting the
cooker hood. If correct, fit the
unit
into position. Tighten the screws if
necessary.
Wall mounting installation:
1.
To mount on the wall, drill two
10mm diameter
holes 538/696mm
with the vent hole on the top
of the
cooker hood in the middle as below
picture.
Make sure the hood is
aligned directly over the hob.
2.
Insert two plastics wall plugs
(supplied) into the holes.
3.
Insert two screws into the upper two plastic wall
plugs and tighten
them leaving 3mm protruding
from the wall.
4.
Mount the cooker hood onto the two screws and mark
the bottom two
screw positions.
5.
Remove the hood and drill the bottom two screw
holes and Insert the
plastic wall plugs.
6.
Mount the hood on the top screws, Insert the bottom
screws and fully tighten all the screws.
Information
The air must not be discharged into a flue that is used for exhausting
fumes
from appliances burning gas or other fuels.
130
480/696
70
100
180
538/696
21
Bekijk gratis de handleiding van Brandt BHC6601X, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Brandt |
| Model | BHC6601X |
| Categorie | Afzuigkap |
| Taal | Nederlands |
| Grootte | 5885 MB |
