Bora MS 140 handleiding
Handleiding
Je bekijkt pagina 34 van 40
EN
80
Installation
www.bora.com
Adjusting the depth of the front
i
The opening mechanism can be used to
move the front forwards or backwards (up to
3 mm).
Fig. 9.15 Adjusting the depth of the front
X Adjust the depth of the front.
X To do this, turn the mechanism on the bottom of
the drawer using a 5 mm Allen key.
9.5.2 Fitting the BORA glass front
(MSF290/MSF140)
i
If the BORA multi-drawer is installed with
a BORAXBO steam oven, the BORAmulti-
drawer glass front can only be fitted after
installing the BORAXBO.
i
To fit the glass front, do not under any
circumstances remove the protective strips
from the adhesive pads on the front support.
The glass front is only to be attached with
screws.
Horizontal adjustment of the front
i
The front fastenings enable the horizontal
clearance to be adjusted after fitting (top and
bottom).
Fig. 9.14 Adjusting the horizontal clearance
X Insert the two screws on the left and right-hand
side of the front support but do not tighten.
X Close the drawer.
X Even out any visual differences in the clearance.
X To do this, slide the front panel to the correct
position using your hands.
X Open the drawer and tighten the screws on the
sides (torque: 1.8 Nm ±10%).
i
If not screwed in correctly, the front can
become loose and fall off. Ensure that
all screws are used and are tightened
accordingly.
Bekijk gratis de handleiding van Bora MS 140, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bora |
| Model | MS 140 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4589 MB |