Baofeng UV-7B handleiding

Niet gecategoriseerd

Baofeng

37 pagina's

PDF beschikbaar

Handleiding

Example. Entering the frequency 436.61250 MHz on display A

(1) In standby mode, press and hold the

key to switch to the frequency (VFO) mode.

(2) Enter [4][3][6][6][1][2][5] [0] on the numeric keypad.

WARNING!

Just because you can program in a channel does not mean you're automatically authorized to use that frequency. Transmitting on frequencies

you're not authorized to operate on is illegal, and in most jurisdictions a serious offence. However, it is legal in most jurisdictions to listen.

Contact your local regulatory body for further informa

tion on what laws, rules and regulations apply to your area.

5.6 Channel (MR) mode and Channel selection

There are two modes of operation: Frequency (VFO) mode, and Channel or Memory (MR) mode.

For everyday use, Channel (MR) mode is going to be a whole lot more practical than Frequency (VFO) mode. However, Frequency (VFO) mode is very

handy for experimentation out in the field. Frequency (VFO) mode is also used for program

ming channels into memory.

In Channel (MR) mode you can navigate up and down the channel by using the  or  keys or the encoder.

Ultimately which mode you end up using will depend entirely on your use case.

Press and hold the

key to switch the radio between VFO and Channel mode, select Channel mode.

• Operation 1: Press the  or  navigation key to select the channel.

• Operation 2: Input the channel numbers by the keyboard. For example, if you want switch to channel 12, input [0][1][2] a total of 3 digits, and it will switch to

channel 12.

When the voice prompt function is enabled, the corresponding channel will be broadcast by voice.

5.7 Selecting a Bank

A bank is a group of channels with the same property. The radio supports up to 10 banks, with a maximum of 100 channels per bank. To select a bank, do one

of the following:

Press

key go to Menu > Bank, press  or  navigation key to select a bank, and then press key to switch to the selected bank.

The corresponding regional alias will be displayed at the bottom of the screen.

5.8 Making a call

press [P1] key to switch between frequency (VFO) mode and channel (MR) mode.

• Channel mode call: After selecting a channel, hold down the [PTT] key to initiate a call to the current channel. Speak into the microphone with normal tone.

Making a call, the red LED is on.

• Frequency mode call: Press and hold

key to switch to the frequency mode, input the working frequency within the allowable frequency range, and

press and hold the [PTT] key to transmit on the current frequency. Speak into the microphone with normal tone. Making a call, the red LED is on.

• Receive a call: When you release the [PTT] key, you can answer it without any action.

Bekijk gratis de handleiding van Baofeng UV-7B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.