Baby Lock Splendor BLSP8 handleiding
Handleiding
Je bekijkt pagina 77 van 82
BL
2
O
2
1
1
3
BL
2
O
2
1
1
3
BL
2
O
2
1
1
3
Replacing Cutting Blades
Replacing LED Lighting
The fixed blade is made of a special long lasting steel and does not require frequent replacement.
If necessary, contact your nearest authorized Baby Lock retailer for replacement of this cutting
blade.
The upper cutting blade is made of a softer steel material and may require replacement. A spare
cutting blade is provided with the machine for replacement if necessary and is located in the
thread stand accessory compartment.
If for some reason your machine does not cut or perform as it should be, please take your ma
-
chine to your nearest authorized Baby Lock retailer. It is possible that the result of poor cutting
may indicate other problems.
TO REPLACE UPPER CUTTING BLADE proceed as follows:
1. For safety reasons, unplug main power cord.
2. Open front cover and cutting blade cover (fig. A).
3. Remove screw and upper blade (fig. B).
4. Insert new upper blade into blade slot.
5. Insert screw and place upper blade to its highest position.
6. Hold upper blade in place and tighten screw.
7. Check and make sure that the upper section of cutting area of
blade is set 1mm below the fixed blade when upper blade is in
its lowest position (fig.C).
8. Close cutting blade cover and front cover.
Your Baby Lock Splendor is equipped with a long-life LED lighting system, which is not necessary
to change bulbs.
Please contact your authorized Baby Lock retailer to replace the LED unit if needed.
AA
BB
CC
1mm
74
M
A
I
N
T
E
N
A
N
C
E
Bekijk gratis de handleiding van Baby Lock Splendor BLSP8, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Baby Lock |
| Model | Splendor BLSP8 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 18882 MB |
