Baby Lock Gallant XL Stationary handleiding

Niet gecategoriseerd

Baby Lock

60 pagina's

PDF beschikbaar

Handleiding

Gallant XL Staonary User Manual | 25

Hopping Feet

Â IMPORTANT: The Gallant XL Stationary quilting machine does not have a presser foot

lever, or top tension release, like a home sewing machine. On a home sewing machine the

top tension is released when the presser foot is raised, allowing the thread to come freely

out of the machine. When a home machine is threaded the tension discs are released and

open to allow the thread to easily fall between the tension discs. This isn’t the case with the

Gallant XL Stationary quilting machine. The top tension is always engaged and the tension

discs are never open. Therefore the thread must be pulled up, or ossed, between the

tension discs or it will stay outside the discs and oat without tension, causing serious stitch

quality problems.

Your machine comes with two hopping feet: a closed-toe foot (comes installed) and an open-toe

foot. Use the closed-toe foot for everyday quilting, the ruler foot for ruler work, and the open-toe

foot when you need greater stitch visibility (such as when you are micro quilting).

To change the hopping foot

1. Turn o all power to the machine

2. Raise the needle and foot to their highest

position. Remove the foot that is on the

mount by using the 2.5mm hex wrench

to loosen the mounting screw far enough

that you can slide the foot o of the

mount.

3. Slide the desired foot onto the mount.

Note that the opening on the side of the

foot is lined up with the screw. Push the

foot up as far as it will go.

4. Fully tighten the screw with the 2.5mm

hex wrench.

Bekijk gratis de handleiding van Baby Lock Gallant XL Stationary, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.