Axxess MITO-01 handleiding

8 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 3 van 8
MITO-01
3
From the 2-pin harness to the vehicle:
Iftheradioyouareinstallinghasnavigationbuiltin,theMITO-01cansupplythe
necessarynavigationoutputswithsomeadditionalwiring.Followthestepsbelow
toconnectthesewirestothevehicle:
• LocatetheOBD2connectorwhichislocatedbeneaththedriver’sside
dashpanelclosetothecenterconsoleandrunthePinkandBlue/Pink
wiresdowntoit.
• ConnectthePinkwiretopin-6oftheOBD2connector.
• Connectthe Blue/Pinkwiretopin-14oftheOBD2connector.
Connections to be made
(Figure A)
OBD2 connector face view
• Initializetheinterfacebyturningtheignitiononfor30seconds,thenturnthe
ignitionbackoff,andonagain.
• Ifthesubwoofer,orfrontdoorwoofersaretooloud,ornotloudenough,youcan
adjusttheoutputbyfollowingthestepsbelow:
1) LocatetheendoftheMITO-01withthe14-pinharnesswithstrippedleads
andRCAjacks.
2) Usingasmallflat-bladescrewdriver,turnthegainknobclockwisetomakeit
louder,orcounterclockwisetomakeitlower.
Initializing and adjusting
the MITO-01
(Figure A)
Subwoofer control
Front door
woofer control

Bekijk gratis de handleiding van Axxess MITO-01, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkAxxess
ModelMITO-01
CategorieNiet gecategoriseerd
TaalNederlands
Grootte913 MB