Axxess AXTO-MI1 handleiding
Handleiding
Je bekijkt pagina 3 van 8
AXTO-MI1
3
From the 2-pin harness to the vehicle:
If the radio you are installing has navigation built in, the AXTO-MI1 can supply the
necessary navigation outputs with some additional wiring. Follow the steps below
to connect these wires to the vehicle:
• Locate the OBD2 connector which is located beneath the driver’s side
dash panel close to the center console and run the Pink and Blue/Pink
wires down to it.
• Connect the Pink wire to pin-6 of the OBD2 connector.
• Connect the Blue/Pink wire to pin-14 of the OBD2 connector.
Connections to be made
(Figure A)
OBD2 connector face view
• Initialize the interface by turning the ignition on for 30 seconds, then turn the
ignition back off, and on again.
• If the subwoofer, or front door woofers are too loud, or not loud enough, you can
adjust the output by following the steps below:
1) Locate the end of the AXTO-MI1 with the 14-pin harness with stripped leads
and RCA jacks.
2) Using a small flat-blade screwdriver, turn the gain knob clockwise to make it
louder, or counterclockwise to make it lower.
Initializing and adjusting
the AXTO-MI1
(Figure A)
Subwoofer control
Front door
woofer control
Bekijk gratis de handleiding van Axxess AXTO-MI1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXTO-MI1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 920 MB |
