Axxess AXPIO-JT1 handleiding
Handleiding
Je bekijkt pagina 10 van 16
10
WIRING
1. Reassemble the camera into the tailgate by following the
camera removal steps in reverse.
2. Run the wire, following the old camera wiring from the tailgate
to the truck bed. (Figure A)
3. Once inside the vehicle, power the camera via a reverse trigger
from the taillight.
4. Connect the Red wire to the reverse trigger. Connect the Black
wire to a chassis ground.
Note: There is a Red wire located at the opposite end of the
harness with the Yellow RCA, if the user wants the camera
powered with an accessory circuit.
5. Run the wire down the length of the vehicle carefully. (Figure B)
Attention: Make sure not to run the wire near any objects that
emit extreme heat or could catch or pinch the wire.
6. Connect the Yellow RCA to the aftermarket radio. There is a Red
wire with the RCA, this can be used in two ways:
a) This wire can bring a reverse trigger to the front of the
vehicle, if the camera is powered in the rear.
b) This wire can be used to power the camera in the front, if the
camera is powered via an accessory circuit.
(Figure A) (Figure B)
Bekijk gratis de handleiding van Axxess AXPIO-JT1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXPIO-JT1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5696 MB |
