Axxess AXGMLN-34 handleiding
Handleiding
Je bekijkt pagina 4 van 8
4
Chime level adjustment:
• With the vehicle on, turn it off and leave the keys in ignition. Open the driver’s door; chimes will
be heard.
• Wait 10 seconds, and then with a small screwdriver, turn the potentiometer clockwise to raise
the chime level; counterclockwise to lower the chime level.
• When the chime level is at a desired level, remove the keys from the ignition. This will lock the
chime volume at its current level.
OnStar level adjustment:
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME UP or VOLUME DOWN buttons on the steering wheel
to raise or lower the OnStar level.
• If the vehicle does not come equipped with steering wheel controls, find the Black/Yellow wire
on the AXGMLN-34 harness.
• While OnStar is speaking, tap the Black/Yellow wire to ground. Once the OnStar level is set, it
will stay at that level until the Black/Yellow wire is tapped to ground again.
ADJUSTING THE AXGMLN-34INSTALLING THE AXGMLN-34
For the steps below, the L.E.D. located inside the interface can only be seen while active.
The interface does not need to be opened to see the L.E.D.
1. Start the vehicle.
2. Connect the AXGMLN-34 harness to the wiring harness in the vehicle. The L.E.D. will initially be
Green to indicate the interface is powered.
3. After a few seconds the L.E.D. will turn on solid Red while the interface automatically programs
to the vehicle. The radio will shut off at this point. This process should take 5 to 30 seconds.
4. After the interface is programmed, the L.E.D. will turn on solid Green, and the radio will come
back on, indicating programming was successful.
5. Test all functions of the installation for proper operation, before reassembling the dash.
6. If the interface fails to function, refer to “Troubleshooting”.
PROGRAMMING THE AXGMLN-34
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AXGMLN-34 harness, into the interface.
• If an AXSWC (sold separately) will be used, do not connect it until the AXGMLN-34 is
programmed and fully functional.
Attention! Do not connect the AXGMLN-34 harness to the wiring harness in the vehicle just yet.
Bekijk gratis de handleiding van Axxess AXGMLN-34, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXGMLN-34 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 573 MB |
