Axxess AXDIS-FD2 handleiding
Handleiding
Je bekijkt pagina 8 van 8
AxxessInterfaces.com © COPYRIGHT 2024 METRA ELECTRONICS CORPORATION REV. 11/22/24 INSTAXDIS-FD2
INSTALLATION INSTRUCTIONS
AXDIS-FD2
Metra recommends MECP
certified technicians
Having difficulties? We’re here to help.
Contact our Tech Support line at:
386-257-1187
Or via email at:
techsupport@metra-autosound.com
Tech Support Hours (Eastern Standard Time)
Monday - Friday: 9:00 AM - 7:00 PM
Saturday: 10:00 AM - 5:00 PM
Sunday: 10:00 AM - 4:00 PM
TROUBLESHOOTING
Resetting the AXDIS-FD2
1. The Blue reset button is located inside the interface, between the two connectors.
The button is accessible outside the interface, no need to open the interface.
2. Press and hold the reset button for two seconds, and then let go to reset the interface.
3. Refer to the Programming section (page 4) from this point.
Dual Assignment Instructions (Long Button Press)
continued from previous page
4. Go to the next step once the Volume-Up button has been pressed the desired number of times.
Caution: If more than (10) seconds elapses between pressing the Volume-Up button, this procedure will abort, and the LED will
go out.
5. To store the long press button in memory, press the button that you assigned a long press button to (the button held down in
Step 2). The LED will now go off indicating the new information has been stored.
Note:
These steps must be repeated for each button you would like to assign a Dual Purpose feature to. To reset a button
back to its default state, repeat Step 1, and then press the Volume-Down button. The LED will go out, and the long press
mapping for that button will be erased.
Bekijk gratis de handleiding van Axxess AXDIS-FD2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXDIS-FD2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 849 MB |
