Axxess AXDIS-CL2 handleiding
Handleiding
Je bekijkt pagina 5 van 12
5
REV. 5/15/25 INSTAXDIS-CL2
INSTALLING THE AXDIS-CL2
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AXDIS-CL2 harness, into the
interface.
Attention!
Do not connect the AXDIS-CL2 harness to the wiring harness in the vehicle just yet.
Attention!
If retaining steering wheel controls, ensure that the jack/wire is connected to the
radio before proceeding. If this step is skipped, the interface will need to be reset for the
steering wheel controls to function.
There are (2) different methods for programming the AXDIS-CL2, depending on the vehicle
being worked on.
For the following applications:
BUICK
Century ................ 2004-2005
LaCrosse ............... 2005-2009
Regal .............................. 2004
Rendezvous ..........2002-2007
Terraza ..................2005-2007
CHEVROLET
Corvette ................ 2005-2013
Impala ..................2000-2005
Monte Carlo ......... 2000-2005
Uplander .............. 2005-2008
OLDSMOBILE
Alero .....................2001-2004
Intrigue ...........................2002
PONTIAC
Aztec .....................2001-2005
Grand Am .............2001-2005
Grand Prix ............2004-2008
Montana SV6 ....... 2005-2006
SATURN
Relay .....................2005-2007
Continued on the next page
PROGRAMMING THE AXDIS-CL2
For the steps below, the LED located inside the interface can only be seen while active. The
interface does not need to be opened to see the LED
1. Start the vehicle.
2. Connect the AXDIS-CL2 harness to the wiring harness in the vehicle.
3. The LED will initially turn on solid Green, then turn off for a few seconds while it auto
detects the radio installed.
4. The LED will then flash Red up to (26) times indicating which radio is connected to the
interface, and then turn off for a couple of seconds. Pay close attention to how many red
flashes there are. This will help in troubleshooting, if needed. Refer to the LED feedback
section for more information.
5. After a couple seconds the LED will turn on solid Red while the interface auto detects the
vehicle. The radio will shut off at this point. This process should take 5 to 30 seconds.
Bekijk gratis de handleiding van Axxess AXDIS-CL2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXDIS-CL2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1459 MB |
