Axxess AXDI-MB1 handleiding
Handleiding
Je bekijkt pagina 2 van 8
2
CONNECTIONS
From the LD-AX-XSVI-MB1 or LD-AX-XSVI-MB2 harness to the aftermarket radio, connect the:
• Black wire to the ground wire.
• Yellow wire to the battery wire.
• Red wire to the ignition wire.
• Orange wire to the illumination wire. If the aftermarket radio has no illumination wire, tape
off the Orange wire.
• Blue wire to the antenna turn on wire.
• White wire to the left front positive speaker output.
• White/Black wire to the left front negative speaker output.
• Gray wire to the right front positive speaker output.
• Gray/Black wire to the right front negative speaker output.
• Green wire to the left rear positive speaker output.
• Green/Black wire to the left rear negative speaker output.
• Purple wire to the right rear positive speaker output.
• Purple/Black wire to the right rear negative speaker output.
The following wires are for the aftermarket radios that have navigation built in:
• Connect the Light Green wire to the parking brake wire of the aftermarket navigation radio
(if applicable).
•
Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket navigation radio
(if applicable).
• Connect the Green/Purple wire to the reverse wire of the aftermarket navigation radio
(if applicable).
AXSWC pre-wired harness:
• This harness is to be used in conjunction with the optional AXSWC (not included) to retain
steering wheel controls. If the AXSWC is not being used, disregard this harness. If it will be
used, please refer to the AXSWC instructions for radio connections and programming.
Note: Disregard the harness that comes with the AXSWC.
Bekijk gratis de handleiding van Axxess AXDI-MB1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXDI-MB1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 867 MB |
