Axxess AX-LOC6.6-PRO handleiding

Niet gecategoriseerd

Axxess

16 pagina's

PDF beschikbaar

Handleiding

REV. 1/16/25 INSTAX-LOC6.6-PRO

1. Connect your 12 volt and ground wires to the terminals. 14-16 gauge wire is recommended.

2. By default the LOCs Turn On Mode is set to DC Offset. Other turn on options are available and described in the Turn On Signal Feature Breakdown portion of this manual.

3. Connecting your Speaker Inputs can happen in a few different places based on your factory system.

a. If your vehicle doesn’t have an OE amplifier your best option is to use the speaker wires located behind the radio or the speaker wires connected to the rear speakers. Your

LOC only requires two inputs, we recommend a left and right signal full range signal.

b. If your vehicle has a factory amplifier, they typically output different frequency ranges from each channel to protect the OE speakers. Summing the channels involves

combining the individual speaker outputs into a single signal that covers the entire audio spectrum. Recommended connections below.

i. Connect Tweeter output from OE amp to channels 1 and 2

ii. Connect Mid/Woofer output from OE amp to channels 3 and 4

iii. Connect Subwoofer output from OE amp to channels 5 and 6

CONNECTIONS/SETUP

Bekijk gratis de handleiding van Axxess AX-LOC6.6-PRO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.