Axxess AX-LOC6.6-PRO handleiding
Handleiding
Je bekijkt pagina 13 van 16
13
REV. 1/16/25 INSTAX-LOC6.6-PRO
GAIN SETUP
Setting gains is very important, if done incorrectly you can damage your speakers. It
is recommended that all settings be adjusted by a professional. Axxess LOCs have a
maximum output of 9.5Vrms. On average aftermarket amplifiers have a maximum input
voltage range of 3-6 volts.
When adjusting the gains it is important to understand the input sensitivity of your
aftermarket equipment and adjust the output levels of the LOC to match. If the output
levels of the LOC are increased beyond the input capabilities of the amplifier, it will cause
the input stage of the aftermarket amplifier to clip, creating distortion. The fix would be to
lower the output levels of the LOC until the distortion is removed.
Basic Setup - No Tools Required
1. Before turning your system on, set all levels and gains to minimum. This includes the
LOC and all aftermarket amplifiers.
2. On your radio make sure all audio adjustments i.e. Bass, Treble, Balance and Fade are
all Centered and Flat. Turn Loudness off and any preset EQ to Flat.
3. While playing a Pink noise track or a song with dynamic sound, increase radio’s
volume to 3/4 of the way up.
4. Adjust the output levels of the LOC slowly until the clipping indicator activates, then
reduce the levels so the indicator light doesn’t come on.
5. Do NOT adjust the amplifier’s gain.
Advanced Setup - Tools Required: Digital Multi-meter, Test Tones
1. During this setup process the RCAs between the LOC and aftermarket amplifier need
to be disconnected. They will be reconnected in Step 11.
2. Set all levels to Minimum on the LOC.
3. On your radio make sure all audio adjustments Bass, Treble, Balance, and Fade are
all Centered and Flat. Turn Loudness off and any preset EQ to Flat.
4. Open the manual for the aftermarket amplifier and look for Line Input Maximum
Sensitivity on the specifications page. This measurement will be in volts. (i.e. 3Vrms 6Vrms)
5. If setting gains for a full range system, play a 1 kHz tone through your radio into the
LOC. If setting levels for a subwoofer, play a 100 Hz tone from the factory radio into
the LOC.
6. Turn the radio all the way up, you should not hear the tone playing.
7. Using a Digital Multi-meter set to Volts AC, touch the Black lead to the OUTPUT RCA
shield and insert the Red lead to the center of the RCA OUTPUT. You will see a voltage
reading show on the Multi-meter’s screen.
8. Adjust the OUTPUT LEVEL of the LOC until the voltage shown on the screen matches
the Line Input Maximum Sensitivity of the aftermarket amplifier. If the Maximized
light comes on before the level is reached, reduce OUTPUT LEVEL until the light is off.
9. Repeat Steps 7 and 8 for the rear output.
10. Turn the radio’s volume down
11. Connect the RCAs from aftermarket amplifier to the LOC.
12. Adjust the gain on your amplifier(s) to minimum.
13. Refer to the amplifier’s manual if additional adjustments are required.
Bekijk gratis de handleiding van Axxess AX-LOC6.6-PRO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AX-LOC6.6-PRO |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1444 MB |
