Axxess AX-BRC-PRO handleiding
Handleiding
Je bekijkt pagina 7 van 12
7
REV. 9/6/23 INSTAX-BRC-PRO
GAIN SETUP
Setting gains are very important, if done incorrectly you can damage your speakers. It is
recommended that all setting be adjusted by a professional. Axxess LOCs have a maximum
output of 10v RMS. On average aftermarket amplifiers to have a maximum input voltage range
of 3-6 volts. When adjusting the gains it is important to understand the input sensitivity of your
aftermarket equipment and adjust the output levels of the LOC to match. If the output levels of
the LOC are increase beyond the input capabilities of the amplifier it will cause the input stage of
the aftermarket amplifier to clip, creating distortion. The fix would be to lower the output levels
of the LOC until the distortion is removed.
Basic Setup - No Tools Required
1. Before turning your system on, set all levels and gains to minimum. This includes the LOC
and all aftermarket amplifiers.
2. On your radio make sure all audio adjustments i.e. Bass, Treble, Balance and Fade are all
Centered and Flat. Turn Loudness off and any preset EQ to Flat.
3. While playing a pink noise track or a song with dynamic sound, increase radio’s volume to
3/4 of the way up.
4. Adjust the output levels of the LOC slowly until the clipping indicator activates, then reduce
the levels so the indicator light doesn’t come on.
5. Press the Bass Enhancement Knob making sure the LED is lit. Bass Enhancement is engaged.
6. Turn EFFECT gain to half.
7. Adjust FREQ to 50HZ
8. Adjust Subsonic Filter to 25Hz
9. Cycle the WIDTH from Narrow to Wide until the Bass sounds good.
10. On the EFFECT gain adjust up and down until the Bass sound good.
11. The outside ring of the bass knob will adjust the Bass Effect Level on the fly.
12. Push bass knob to turn on and off.
13. Do not adjust the amplifier’s gain.
NOTE: If at any point during the adjustments of the Enhancement circuit the Maximized
LED lights up simply reduce the gain adjustment on the AX-BRC-PRO until it is no longer lit.
Advanced Setup - Tools required: Digital Multi-meter, Test tones
1. During this setup process the RCAs between the LOC and aftermarket amplifier need to be
disconnected. They will be reconnected in step 19.
2. Set all levels to minimum on the LOC
3. On your radio make sure all audio adjustments i.e. Bass, Treble, Balance and Fade are all
Centered and Flat. Turn Loudness off and any preset EQ to Flat.
4. Open the manual form the aftermarket amplifier and look for Line Input Maximum
Sensitivity on the specifications page. This measurement will be in volts. (i.e. 3vrms 6vrms)
5. If setting gains for a full range system play a 1 kHz tone through your radio into the LOC. If
setting levels for a subwoofer play a 100 Hz tone from the factory radio into the LOC.
6. Turn the radio all the way up, you should not hear the tone playing.
Bekijk gratis de handleiding van Axxess AX-BRC-PRO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AX-BRC-PRO |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1124 MB |
