Audient EVO SP8 handleiding

Handleiding

123456789101112131415161718192021222324252627/ 27

Afdrukken

Je bekijkt pagina 15 van 27

HARDWARE HARDWARE

Factory Reset

Clocking Congurations

A Factory Reset will return the unit to its default state and any settings will

be removed. Please note that a factory reset cannot be undone so use this

option with care.

When you are using multiple devices together with digital connections such

as ADAT, it’s vital that they all remain in sync with each other. The process of

syncing up your devices is known as ‘clocking’.

In your setup, you must choose one device to be the primary clock and all

other devices in the system will be replica clocks. It’s important that there

is only one primary clock in your system. Having multiple primary clocks will

cause the devices to go out of sync and cause distortion on your recordings.

The primary clock sends a very fast ticking signal to the replica device. This

ticking signal can either be sent via a dedicated connection for the clock,

such as the BNC Word Clock Input on the EVO SP8, or sent alongside your

audio data on an ADAT connection.

Choosing the Primary Clock Device

Channel Count per Connection

Typically, you would want to choose the device that is directly connected to the

computer to be the primary clock. This clock can then be sent to other devices

in your system using either its ADAT Outputs or a BNC Wordclock Output.

The main advantage of this is that any changes in sample rate on the computer

will automatically be sent to the other devices in the setup and everything will

remain in sync.

Otherwise, you can use the SP8 as the primary clock instead. This would send

the clock to another device via its ADAT Outputs. This can only be done on

simple setups (1x EVO SP8 and 1x EVO 16 for example) but when more devices

are involved, it’s best to make use of a BNC Word Clock connection.

At sample rates of 44.1 and 48kHz, each optical connection will carry 8 ADAT

channels. When the sample rate is increased to 88.2kHz or 96kHz, this channel

count drops due to how the ADAT protocol works. At these higher sample rates,

two TOSlink cables per connection will be required to access all 8 channels.

EVO SP8 does not support 176.4 or 192kHz sample rates.

Status

Brightness

Output Source

Factory Reset

123456789101112131415161718192021222324252627/ 27

Bekijk gratis de handleiding van Audient EVO SP8, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd