Audient EVO SP8 handleiding
Handleiding
Je bekijkt pagina 14 van 27
HARDWARE HARDWARE
Output Source
Status
Here you can change what signal is sent to the 8 line outputs of the EVO SP8.
When set to ‘Digital’ the 8 ADAT input channels are sent to the 8 Line Outputs
allowing the EVO SP8 to be used as a 8 channel D to A converter. Otherwise,
the ‘Analogue’ setting will send the outputs of the 8 Preamps directly to the
Line Outputs to allow the SP8 to be used as a standalone mic pre.
The Status screen shows the current sample rate and the status of the clock
on the DIGI and Word Clock Inputs.
A green indicator dot next to an input indicates that the EVO SP8 has
successfully synced to the clock present on this input.
An amber indicator dot next to an input indicates that a valid clock has been
detected but at a dierent sample rate to the SP8’s. Adjust either the SP8 or
the external clock to match.
A red indicator dot indicates that no valid clock has been detected on this
input. In this case, double check your connections or try a dierent cable to
rule out a faulty cable.
Brightness
Enables the brightness of the LEDs on the front panel of the EVO SP8 to be
adjusted to suit the ambience of your studio.
Factory Reset
Status
Brightness
Exit
Brightness
Output Source
Word Clock
Status
Brightness
Output Source
Word Clock
Status
Bekijk gratis de handleiding van Audient EVO SP8, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Audient |
| Model | EVO SP8 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8919 MB |