Atlona AT-UHD-CLSO-840 handleiding
Handleiding
Je bekijkt pagina 54 van 76
AT-UHD-CLSO-840
54
Advanced Operation
In control mode, RS-232 commands are sent from a computer or control system (DTE) to the AT-UHD-CLSO-840
(DCE). This method allows direct control of the matrix for routing, IP conguration, powering-on / powering-o and
other functions.
Control mode
RS-232
2
COM
NC
NO
COM
NC
NO
COM
NC
NO
COM
NC
NO
+12V
SIG
GND
+12V
SIG
GND
+12V
SIG
GND
+12V
SIG
GND
1
COMPONENT
HDMI
1
2
3
4
5
6
SERIAL 1
IR OUT
SERIAL 2
L
R
DIGITAL
COAX OUT
AUDIO OUT AUDIO IN
ETHERNET
2 3 4
VIDEO OUT
48V DC
FACTORY
RESET
AT-UHD-CLSO-840
Automation Control System
AT-UHD-CLSO-840
FCN CANCEL EDID
INFO
POWER ENTER
1. Connect the RS-232 cable between the control system and the AT-UHD-CLSO-840. Refer to Cable Assembly
(page 51) for instructions on preparing the cable.
2. Set the baud rate of the computer/control system to 115200. If the control system is not set to this baud rate,
then the AT-UHD-CLSO-840 will not respond to RS-232 commands.
3. Refer to the Applications Programming Interface for a listing of available commands.
NOTE: The RS-232 port on the AT-UHD-CLSO-840 runs at a baud rate of 115200. The control unit
must be set to the same baud rate, in order to communicate with the AT-UHD-CLSO-840.
Bekijk gratis de handleiding van Atlona AT-UHD-CLSO-840, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-UHD-CLSO-840 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11442 MB |
