Atlona AT-UHD-CLSO-840 handleiding
Handleiding
Je bekijkt pagina 52 van 76
AT-UHD-CLSO-840
52
Advanced Operation
In pass-through mode, RS-232 commands are sent to the AT-UHD-CLSO-840 and then transmitted over HDBaseT to
the receiver unit, and then to the display (sink) device.
Pass-through mode
RS-232
HDBaseT
(HDBaseT OUT 3)
RS-232
2
COM
NC
NO
COM
NC
NO
COM
NC
NO
COM
NC
NO
+12V
SIG
GND
+12V
SIG
GND
+12V
SIG
GND
+12V
SIG
GND
1
COMPONENT
HDMI
1
2
3
4
5
6
SERIAL 1
IR OUT
SERIAL 2
L
R
DIGITAL
COAX OUT
AUDIO OUT AUDIO IN
ETHERNET
2 3 4
VIDEO OUT
48V DC
FACTORY
RESET
AT-UHD-CLSO-840
AT-UHD-100CE-RX
Display
Automation Control System
AT-UHD-CLSO-840
FCN CANCEL EDID
INFO
POWER ENTER
DC 48V RS-232 HDBaseT IN HDMI OUT
RX TX
1. Connect the RS-232 cable between the control system and the AT-UHD-CLSO-840. Refer to Cable Assembly
(page 51) for instructions on preparing the cable.
2. Connect an Ethernet cable from the desired HDBaseT OUT port to a receiver. In this example, the HDBaseT
cable is connected from HDBaseT OUT 3 to an AT-UHD-100CE-RX receiver.
3. Connect an RS-232 cable between the display (sink) and the receiver.
Bekijk gratis de handleiding van Atlona AT-UHD-CLSO-840, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-UHD-CLSO-840 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11442 MB |
