Atlona AT-UHD-CLSO-840 handleiding
Handleiding
Je bekijkt pagina 45 van 76
AT-UHD-CLSO-840
45
Basic Operation
1. Verify that a display or other sink device is connected to the output from which the EDID will be read. In this
example, a display is connected to HDMI OUT 1.
2. Login to the web GUI. Refer to Introduction to the Web GUI (page 55) for more information.
3. Click EDID, under the Conguration section in the menu bar on the left side of the screen.
4. Click the EDID Memory drop-down list for the output, where the sink is connected, and select the memory
location. Each of the four outputs has an associated memory location: Output_1 = EDID Memory 1, Output_2
= EDID Memory 2, and so on.
4. Click the Save button to commit changes. If the EDID is recorded successfully, then a message will be displayed
indicating that the EDID was saved to the selected memory location.
The stored EDID can now be copied to any of the available inputs, as shown in the illustration, below. Refer to
EDID Management (page 41) for more information.
To clear all stored EDID data from the AT-UHD-CLSO-840, click the EDID Reset button, shown in the illustration
above.
Using the web GUI
Bekijk gratis de handleiding van Atlona AT-UHD-CLSO-840, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-UHD-CLSO-840 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11442 MB |
