Atlona AT-UHD-CAT-2 handleiding
Handleiding
Je bekijkt pagina 24 van 45
AT-UHD-CAT-2
24
1. Remove at least 3/16” (5 mm) of insulation from the RX and GND wires of the emitter.
2. Locate the included 5-pin captive screw block and open each of the terminals by turning the screws counter-
clockwise, using a small regular screwdriver.
3. Insert the S (signal) lead of the IR emitter to the TX terminal on the AT-UHD-CAT-2 captive screw connector.
Tighten the screw to secure the wire but do not overtighten.
4. Insert the GND lead of the IR emitter to the GND terminal on the AT-UHD-CAT-2 captive screw connector.
Tighten the screw to secure the wire but do not overtighten.
5. Connect the captive screw connector to the RS-232 / IR IN port of the zone to be controlled.
Controlling Source Devices
IR Emitter
(RS-232 / IR 1)
HDBaseT
(HDBaseT OUT 1)
IR Receiver
AT-UHD-CAT-2
Blu-ray Player
IR Remote
Blu-ray Player
21OUTIN
HDMI HDBaseT LOCK
EDIDPOWER
AT-UHD-CAT-2
INT LEARN
IR Signal
POWER
LINKFW
AT-UHD-EX-70C-RX
AT-UHD-EX-70C-RX
Device Operation
TX TXRX
RX
21
21
RS-232
MASTER
IN
OUT
LAN
HDMI HDBaseT OUT DC 48V
IR FW
TX TXRX RX
RS-232 IR
TX TXRX RX
RS-232 IR
21OUTIN
HDMI HDBaseT LOCK
EDIDPOWER
AT-UHD-CAT-2
INT LEARN
S
GND
AT-UHD-CAT-2
IR Emitter
GND
TX
6. Place the IR emitter next to the source device, as shown in the illustration below.
Bekijk gratis de handleiding van Atlona AT-UHD-CAT-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-UHD-CAT-2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5847 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 1660 g |
| Breedte | 44 mm |
| Diepte | 254 mm |
| Hoogte | 219.5 mm |
