Atlona AT-UHD-CAT-2 handleiding
Handleiding
Je bekijkt pagina 23 van 45
AT-UHD-CAT-2
23
Device Operation
IR can be used to control either source devices at the headend or devices connected to the receiver endpoint, such
as a display. Note that the MASTER RS-232 / IR port does not support IR control. Note that each RS-232 / IR
port is assigned to an HDBaseT OUT port. This assignment is xed and cannot be changed, as shown in the table
below. IR is compatible with frequencies from 30 kHz to 60 kHz.
1. Remove at least 3/16” (5 mm) of insulation from the TX and GND wires.
2. Locate the included 5-pin captive screw block and open each of the terminals by turning the screws counter-
clockwise, using a small regular screwdriver.
3. Insert the TX and GND wires into correct terminal, as shown, and tighten the screws to secure each wire. Do not
overtighten.
4. Connect the captive screw connector to the RS-232 / IR IN port of the zone to be controlled.
5. Connect the RX terminal, from the AT-UHD-CAT-2, to the TX terminal on the control system.
6. Connect the GND terminal, from the AT-UHD-CAT-2, to the GND terminal on the control system.
TX TXRX
RX
21
21
RS-232
MASTER
IN
OUT
LAN
HDMI HDBaseT OUT DC 48V
IR FW
TX TXRX RX
RS-232 IR
TX TXRX RX
RS-232 IR
21OUTIN
HDMI HDBaseT LOCK
EDIDPOWER
AT-UHD-CAT-2
INT LEARN
IR Control
Controlling Display Devices
RS-232 / IR Port HDBaseT Port
RS-232 / IR 1 HDBaseT OUT 1
RS-232 / IR 2 HDBaseT OUT 2
IR
(RS-232 / IR 1)
HDBaseT
(HDBaseT OUT 1)
IR Emitter
2
COM
NC
NO
COM
NC
NO
COM
NC
NO
COM
NC
NO
+12V
SIG
GND
+12V
SIG
GND
+12V
SIG
GND
+12V
SIG
GND
1
COMPONENT
HDMI
1
2
3
4
5
6
SERIAL 1
IR OUT
SERIAL 2
L
R
DIGITAL
COAX OUT
AUDIO OUT AUDIO IN
ETHERNET
2 3 4
VIDEO OUT
48V DC
FACTORY
RESET
AT-UHD-EX-70C-RX
Display
Control System
AT-UHD-CAT-2
21OUTIN
HDMI HDBaseT LOCK
EDIDPOWER
AT-UHD-CAT-2
INT LEARN
IR Signal
POWER
LINKFW
AT-UHD-EX-70C-RX
7. Connect the IR emitter to the receiver and place the emitter
next to the display (sink) device, as shown in the illustrator
below.
TX
GND
AT-UHD-CAT-2
Control System
GND
RX
Bekijk gratis de handleiding van Atlona AT-UHD-CAT-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-UHD-CAT-2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5847 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 1660 g |
| Breedte | 44 mm |
| Diepte | 254 mm |
| Hoogte | 219.5 mm |
