American Audio 10MXR BT handleiding
Handleiding
Je bekijkt pagina 11 van 19
©American Audio® - www.americanaudio.us - 10MXR BT Instruction Manual Page 11
10MXR BT CONTROLS aNd FUNCTiONS
16. GND (GROUND TERMINAL) - Be sure to connect turntable ground leads to either or both of
the two available ground terminals. This will reduce the humming and popping noises associated
with magnetic phono cartridges.
17. CHANNEL LINE LEVEL SELECTOR SWITCHES - These switches are used to change the volt-
age line levels of there respected Phono / Line RCA inputs jacks. When connecting turntables with
magnetic cartridges to these jacks be sure the corresponding switch is in the “PHONO” position,
and when using line level input devices be sure this switch is in the “LINE” position. Always be sure
main power is shut o before change the position of the Line Level Selector Switch.
18. ANTENNA - This antenna is used to receive a incoming Bluetooth™ signal. When pairing with
a Bluetooth™ signal, the device name will show up as “10MXRBT”.
19. HEADPHONE JACK - This jack is used to connect your headphones to the mixer allowing you to
monitor the cue source. Use headphones only rated at 8 ohms to 32 ohms. Most DJ headphones are
rated at 16 ohm, these are highly recommended. Always be sure the CUE LEVEL VOLUME (6) is set to
minimum before you put the headphones on.
20. MICROPHONE CONNECTOR - This jack is used to a connect a microphone to the mixer. Con-
nect you microphone via this 1/4 inch (6.3mm) jack. The volume output level for this microphone will
be controlled by its own respective MICROPHONE GAIN CONTROL (15). Note: We recommend that
you use a 500-600ohm microphone for the best sound quality.
21. CHANNEL 1: LINE 1 INPUTS - These Jacks are used for line level inputs. CD players, Tape
Decks, and other line level instruments may be connected to these jacks. The red colored RCA jack
represents the right channel input and the white represents the left channel input. Input volume will
be controlled by the channel one fader. The channel SOURCE SELECTOR SWITCH (1) must be in
the “LINE 1” position, to monitor any source connected to these jacks. Do not connect turntables to
these jacks, turntables should only be connected to “Phono” inputs.
REAR PANEL
BOOTH
OUTPUTS
P H2
LN-5
P H1
LN-3
FUSE 250V 0.5A
AC INPUT 50/60Hz
23 22
19
24 2021
29
28 25
30
16 17 18
2627
Bekijk gratis de handleiding van American Audio 10MXR BT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | American Audio |
| Model | 10MXR BT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2576 MB |
