Amcrest AMDV5M32 handleiding
Handleiding
Je bekijkt pagina 7 van 93
7
Hard Drive Installation
Hard drives are typically sold separately, when installing a hard drive to the device, please make sure to
use a hard drive with 7200rpm or higher. Please follow the instructions below to install a hard disk drive
(HDD).
All the figures listed below are for reference only. Slight differences may be found on the front or rear
panel.
The DVR has connections for only 1 hard drive inside the case and the hard drive must be no
bigger than 10TB (Terabytes).
To install your hard drive, the following is needed:
A medium sized (regular) Phillips-head screwdriver - not included
A hard drive - not included (unless you purchased a ‘kit’ that does have one included)
Four hard drive fastening screws - included
Note: Before installing the hard drive, make sure the DVR is powered off and completely
disconnected from power.
1. Loosen the screws on
the upper cover and side
panel.
2. Attach four screws in the HDD
(Turn three times.)
3. Place the HDD in accordance
with the four holes on the bottom.
4. Turn the device over
secure the screws.
5. Connect the HDD data cable
and power cable to the HDD.
6. Attach the cover onto the DVR
and secure it using the screws.
Once the hard drive is installed, turn on the DVR. If the hard drive for your DVR was not setup
properly you may hear a beeping noise. This indicates the DVR does not have the proper
connection with your hard drive.
Bekijk gratis de handleiding van Amcrest AMDV5M32, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Amcrest |
| Model | AMDV5M32 |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 23088 MB |
