Alpine TUE-T152 handleiding
Handleiding
Je bekijkt pagina 15 van 18
FR
ES
DE
SE
IT
13-EN
TV Antenna Mounting Method
1 Determine the mounting location.
Determine the mounting locations at left and
right corners of the rear window. (Fig.1).
2 Peel off the base paper and put on the
antenna. Clean dirty of the mounting locations,
and then put on the antenna.
3 Pinch the antennas and fix them onto the
window panel, by using the attached antenna
fixing clamps. (Fig. 2)
NOTES
• Before put on the antenna, heating the mounting
locations with a hair dryer will assure good result.
• Do not apply any humidity and force within 24 hours
after putting on the antenna.
• In order to keep the good reception, be sure to put the
antenna cable firmly to the body-side of the car
(metal part) when wiring it from the element part to
the side of the car-room.
• Reception may be a bit worse in the car whose
window glasses are of the type not allowing airwaves
to go through.
Rear window
Rear seat
Long
Short
Antenna
clamper
Antenna
cable
Element
1 Press the double-sided adhesive tape onto the
back of the remote control sensor unit.
2 Before completing the sensor mounting, make
sure the location selected is within the operating
range of the remote control. Peel off the backing
of the adhesive tape and press the sensor onto
the selected mounting location, or inside of the
remote control holder.
To prevent external noise from entering the
audio system.
• Locate the unit and route the leads at least
10cm away from the car harness.
• Keep the battery power leads as far away from
other leads as possible.
• Connect the ground lead securely to a bare
metal spot (remove the coating if necessary) of
the car chassis.
• If you add an optional noise suppressor,
connect it as far away from the unit as possible.
Your Alpine dealer carries various Alpine noise
suppressors, contact them for further
information.
• Your Alpine dealer knows best about noise
prevention measures so consult your dealer for
further information.
Remote Control
Sensor Unit
Fig.1
Fig.2
Remote Control Sensor Unit Mounting
Method
NOTES
• The remote control sensor unit is used only when
operating TUE-T152 from the rear monitor.
• When mounting the unit with double-sided adhesive
tape, make sure the mounting surface is dry and
free from dirt or grease.
Bekijk gratis de handleiding van Alpine TUE-T152, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alpine |
| Model | TUE-T152 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1742 MB |
