Advantech PCL-730 handleiding
Handleiding
Je bekijkt pagina 3 van 4
Startup Manual 3
Please refer to the below jumper and switch locations
on PCL-730.
Base address selection (SW1)
You control the PCL-730's operation by reading or writ-
ing data to the PC's I/O (input/output) port addresses.
The PCL-730 requires four consecutive address loca-
tions. Switch SW1 sets the card's base (beginning)
address. Valid base addresses range from Hex 200 to
Hex 3F0. Other devices in your system may, however,
be using some of these addresses.
We set the PCL-730 for a base address of Hex 300 at
the factory. If you need to adjust it to some other
address range, set switch SW1 as shown in the follow-
ing table:
Note: Switches 1-8 control the PC bus address lines as
shown below:
Interrupt level (JP1)
Jumper JP1 controls the card's IRQ level, as shown
below. Position X disables the interrupt.
Interrupt triggering (JP2)
Jumper JP2 selects the trigger edge (rising or falling) on
which the card will trigger an interrupt. Jumper settings
appear below:
Interrupt source (JP3)
Jumper JP3 selects the source of the card's interrupt.
Switch and Jumper Settings
Switch 12345678
Line A9 A8 A7 A6 A5 A4 A3 A2
Setting Channel Connector
IDI0 Isolated DI Channel 0 CN2 pin1
IDI1 Isolated DI Channel 1 CN2 pin 2
IDI0 TTL DI Channel 0 CN4 pin1
IDI1 TTL DI Channel 1 CN4 pin 2
Bekijk gratis de handleiding van Advantech PCL-730, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | PCL-730 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 689 MB |
