Adler AD 7062 handleiding
Handleiding
Je bekijkt pagina 9 van 160
9
Solution: Check filter and fitting are correct
a. Filter not fitting properly in slot
Possible cause:
3. The device will start in manual mode when switched for the first time.
Warning symbols:
Battery display:
If there is less than 5% of the battery capacity the battery symbol will turn red and flash (D7).
Store the appliance in a dry place and protect it from excessive heat or direct sunlight.
Use the attached wall mount and screws to fasten the wall mount to the wall in a place that is close to a power socket for easy and
convenient charging and storage.
2. To switch the device press the On / Off switch (D4).
a. Eco (D8)
c. Boost (D10)
6. Press the Mode button (D11) to change to manual setting again.
Problem: Appliance is not working.
The current battery capacity is always displayed.
Possible cause:
Use of the device:
The display will be shown fully with all icons visible for approximately 1 second when the device is switched on. After that only the active
functions will stay illuminated. The battery status is always displayed.
4. You can choose between different suction strengths by touching the touch display on the handle and choose between 3 settings:
5. Pressing the upper half of the On off switch (D11) will switch the device to Automatic mode. You will notice the display will change from
Manual (D5) to Auto (D6) and the white line will rise or shrink depending on the suction power needed.
1. Please check if the device is fully loaded.
Storage:
Display functions:
Wall mount:
b. Normal (D9)
During use warning symbols might light up in the display. Please consult the end of this manual for troubleshooting.
Troubleshooting:
If there is less than 20 % of the battery capacity the battery symbol will flash green (D7).
a. Appliance or charging station is not correctly connected to a power socket
b. Brush roller is blocked Solution: Clean brush roller
Solution: Clean the filters, replace the HEPA filter if necessary
Problem: Battery will not charge.
Possible cause:
Solution: Connect the mains adaptor correctly to a functioning power socket
Possible cause:
a. Battery is empty Solution: Charge battery
Solution: Hang the hand-held appliance correctly in the charging station
Problem: Suction power decreases
a. Suction opening on the container is blocked
b. Dust container is full
Solution: Empty the dust container
c. Filters are dirty
d. Brush roller is blocked
Solution: Clean the brush roller and remove debris such as hair and fibers if necessary.
Problem: Filter cannot be inserted correctly
b. Contact with charging station has not been established
Solution: Clean the suction opening on the hand-held appliance and check the suction tube for any dirt.
Bekijk gratis de handleiding van Adler AD 7062, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adler |
| Model | AD 7062 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 15114 MB |
