Adj Pixie Driver 2000 handleiding
Handleiding
Je bekijkt pagina 12 van 26
12
DRIVER OUTPUT LIMITATIONS
Your Pixie Driver 2000 is programmed not to allow Pixie Strip xtures to be added in such a way that
the maximum number of pixels per port would be exceeded. This is done by limiting the number of
Pixie Strip units that can be selected in the System Menu based on what has already been set up on
the unit.
If we look at the example from the previous page, where 34 Pixie Strip 30s have been set up on a
single port in Kling-Net mode, the System Menu will not allow any further xtures to be set up on
that port, regardless of model. This is because 34 xtures, times 30 pixels per xture, uses up the
port’s entire capacity of 1020 pixels. If we then tried to set up an additional Pixie Strip 60, the Sys-
tem Menu would not allow any values other than “0” to be selected, because the port does not have
the capacity to support the additional 60 pixels that would be required.
PIXELS IN USE PIXELS FREE
34 x Pixie Strip 30 1020 pixels
1020 pixel capacity
- 1020 pixels in use
____________________
0 pixels free
0 x Pixie Strip 60 0 pixels
0 x Pixie Strip 120 0 pixels
1020 total pixels in use
In this case, we would rst need to “make room” on this driver port by reducing the number of Pixie
Strip 30s that are set up. If we reduce the number of Pixie Strip 30s by two units, we then free up 60
pixels on this driver port.
PIXELS IN USE PIXELS FREE
32 x Pixie Strip 30 960 pixels
1020 pixel capacity
- 960 pixels in use
____________________
60 pixels free
0 x Pixie Strip 60 0 pixels
0 x Pixie Strip 120 0 pixels
960 total pixels in use
Now that we have freed up 60 pixels on this driver port, we are able to add the Pixie Strip 60, as de-
sired. The System Menu now allows you to increase the number of Pixie Strip 60s on this driver port
to 1, but it will not allow you to increase the number any higher because there are not enough pixels
free to add more than 1 Pixie Strip 60. Notice, too, that the only selectable value for Pixie Strip 120s
is “0” due to the fact that 60 free pixels is not enough to run a single Pixie Strip 120.
PIXELS IN USE PIXELS FREE
32 x Pixie Strip 30 960 pixels
1020 pixel capacity
- 1020 pixels in use
____________________
0 pixels free
1 x Pixie Strip 60 60 pixels
0 x Pixie Strip 120 0 pixels
1020 total pixels in use
If you are having trouble adding the desired number of xtures to a driver port, double check the
number of xtures of other Pixie Strip models that have been set up to see if they are using up all of
the available pixel space on that port.
Bekijk gratis de handleiding van Adj Pixie Driver 2000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | Pixie Driver 2000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3129 MB |
