Adj Focus Spot Two handleiding

Niet gecategoriseerd

Adj

18 pagina's

PDF beschikbaar

Handleiding

ADJ Products, LLC - www.adj.com - Focus Spot Two Instruction Manual Page 23ADJ Products, LLC - www.adj.com - Focus Spot Two Instruction Manual Page 22

Pan Invert - Pan Inversion

1. Press the MENU button until “Pan Invert” is displayed, press

ENTER. Either “Yes” or “No” will be displayed.

2. To activate the Pan inversion press the UP or DOWN buttons until

“Yes” is displayed, press ENTER to conm. To deactivate Pan inver-

sion, select “No” and press Enter.

Tilt Invert - Tilt Inversion

1. Press the MENU button until “Tilt Invert” is displayed, press

ENTER. Either “Yes” or “No” will be displayed.

2. To activate the Tilt inversion press the UP or DOWN buttons until

“Yes” is displayed, press ENTER to conm. To deactivate Tilt inver-

sion, select “No” and press Enter.

Back Light - With this function you can make the back-

light automatically turn off after one minute.

1. Press the MENU button until “Back Light” is displayed, press ENTER.

2. Either “On” or “O” will now be displayed. Press the UP or DOWN

buttons to select “On” to keep the backlight on at all times, or “O” to

allow the backlight to turn o after 1 minute. Press any button to turn

the backlight on again.

Auto Test - This function will run a self test program.

1. Press the MENU button until “Auto Test” is displayed, press

ENTER.

2. The xture will now run a self test. Press the MENU button to exit.

LED Temp. - With this function you can display the run-

ning temperature of the unit.

1. Press the MENU button until “LED Temp.” is displayed, press

ENTER.

Focus Spot Two System Menu

DMX State - This mode can be used as a precaution

mode, that in case the DMX signal is lost, the operating mode

chosen in the setup is the running mode the xture will go

into when the DMX signal is lost. You can also set this as

the operating mode you would like the unit to return to when

power is applied.

1. Press the MENU button until “DMX State” is displayed, press ENTER.

2. Either “Master Slave”, “Blackout”, or “Last State” will be displayed.

Choose an operating mode you would like the unit to start up in when

power is applied or the DMX signal is lost.

• Master Slave - If the DMX signal is lost or power is applied, the unit

will automatically go into Master Slave mode.

• Blackout - If the DMX signal is lost or power is applied, the unit will

automatically go into stand by mode.

• Last State - If the DMX signal is lost the xture will stay in the last

DMX set up. If power is applied and this mode is set, the unit will auto-

matically go into the last DMX set up.

3. Press ENTER to conrm your desired set up.

Dimmer Curve - In this mode you can select the dimmer

curve.

1. Press the MENU button until “Dimmer Curve” is displayed, press

ENTER.

2. The current dimmer curve setting will be displayed.

3. Press the UP or DOWN buttons to nd your desired dimmer curve

and press ENTER to conrm. See the Dimmer Curve Chart on page 32

for the dierent settings.

Focus Spot Two System Menu

Bekijk gratis de handleiding van Adj Focus Spot Two, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.