Adj Focus Spot Two handleiding

Niet gecategoriseerd

Adj

18 pagina's

PDF beschikbaar

Handleiding

ADJ Products, LLC - www.adj.com - Focus Spot Two Instruction Manual Page 20 ADJ Products, LLC - www.adj.com - Focus Spot Two Instruction Manual Page 21

Focus Spot Two System Menu

System Menu: When making adjustments press ENTER to

conrm your setup then press and hold the MENU button

for at least 3 seconds. To exit without making any adjust-

ments press the MENU button. The display will lock after 30

seconds, press the MENU button for 3 seconds to unlock.

DMX Address - Set the DMX Address -

1. Press the MENU button until “DMX Addresss” is displayed, press

ENTER.

2. “X” will now be displayed, “X” represents the displayed address.

Press the UP or DOWN buttons to nd your desired address.

3. Press ENTER to conrm, and then press and hold the MENU button

for at least three seconds to assign.

Channel Mode - This will let you select your desired

DMX Channel mode.

1. Press the MENU button until “Channel Mode” is displayed, press

ENTER.

2. “X Chan” will now be displayed, “X” represents the displayed DMX

channel mode. Press the UP or DOWN buttons to nd your desired

Channel mode.

3. Press ENTER to conrm.

Slave Mode - This will let you set unit as a master or

slave in a master/slave conguration.

1. Press the MENU button until “Slave Mode” is displayed, press

ENTER. Either “Master”, “Slave 1” or “Slave 2” will be displayed.

2. Press the UP or DOWN buttons until your desired setting is dis-

played, then press ENTER to conm.

NOTE: In a Master/Slave conguration you can make one xture the

Master and then set the next xture to “Slave 2”, the xtures will now

have contrast movement to each other.

Show Mode - Show modes 0-4 (Factory programs).

Show mode can run with or without sound active mode

active.

1. Press the MENU button until “Show Mode” is displayed, press

ENTER.

2. “Show X” will now be displayed, “X” representing a number between

0-4. Shows 1-4 are factory programs, while show “0” is random mode.

Use the UP or DOWN buttons to nd your desired show.

3. When you have found your desired show press ENTER, then press

and hold the MENU button for at least 3 seconds to activate.

Sound Mode - In this mode the unit will run in sound

active mode.

1. Press the MENU button until “Sound Mode” is displayed, press

ENTER.

2. Either “On” or “O” will now be displayed. Use the UP or DOWN

buttons to toggle between “On” and “O”.

3. Press ENTER to conrm your selection, the press and hold the

MENU button to activate.

Sound Sense - In this mode you can adjust the sound

sensitivity of the sound active mode.

1. Press the MENU button until “Sound Sense” is displayed, press

ENTER.

2. Press the UP or DOWN buttons to adjust the sensitivity level. The

sensitivity level can be adjusted between 0 (the lowest) and 100 (most

sensitive).

3. Press ENTER to set you desired level.

Focus Spot Two System Menu

Bekijk gratis de handleiding van Adj Focus Spot Two, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.