Adj Element QAIP handleiding
Handleiding
Je bekijkt pagina 11 van 29
ADJ Products, LLC - www.adj.com - Element QAIP User Manual Page 10
All xtures should be given a DMX starting address when using a DMX controller, so the correct xture
responds to the correct control signal. This digital starting address is the channel number from which
the xture starts to “listen” to the digital control signal sent out from the DMX controller. The assignment
of this starting DMX address is achieved by setting the correct DMX address on the digital control
display on the xture.
You can set the same starting address for all xtures or a group of xtures, or set dierent addresses
for each individual xture. Setting all xtures to the same DMX address will cause all xtures to react
in the same way, in other words, changing the settings of one channel will aect all the xtures
simultaneously.
If you set each xture to a dierent DMX address, each unit will start to “listen” to the channel number
you have set, based on the quantity of DMX channels of each xture. That means changing the settings
of one channel will only aect the selected xture.
In the case of the Element QAIP, when in 4 channel mode you should set the starting DMX address of
the rst unit to 1, the second unit to 5 (4 + 1), the third unit to 9 (5 + 4), and so on. (See chart below for
more details).
Element QAIP DMX Addressing
Channel Mode
Unit1
Address
Unit2
Address
Unit3
Address
Unit4
Address
4 Channels 1 5 9 13
5 Channels 1 6 11
16
6 Channels 1 7 13
19
9 Channels 1
10 19
28
10 Channels 1
11 21
31
Bekijk gratis de handleiding van Adj Element QAIP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | Element QAIP |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3574 MB |
