Zodiac Vortex-Pro VX40 handleiding
Handleiding
Je bekijkt pagina 13 van 24
• To remove the cleaner from the pool using the remote
control, press (see Figure 20).
The cleaner rotates left until you release the Lift
System button.
4.8 Synchronizing the Remote Control
Even though the remote control is factory-synchronized
to your cleaner's control box, it may be necessary to
synchronize again if you need to replace either the
control box or the remote control.
• To synchronize the remote control to the control box:
Press and hold for 3 seconds to turn on remote.
Plug the control box into a power source.
When the display shows the operating time, press
and simultaneously for six (6) seconds.
• The display shows followed by the
normal operating time display to indicate the cleaner
is now synched with the remote and ready to begin
operating in remote control mode.
4.9 Storing the Cleaner
The cleaner must be cleaned regularly using slightly
soapy clean water. Do not use solvents such as acetone
or its equivalent. Rinse the cleaner generously using
clean water. Do not let your cleaner dry in direct
sunlight near the pool.
NOTE: ForVX504WDandVX554WDmodels,itis
recommendedthatthecleanerisstoredonitscaddy
fordrying(seeFigure23).
1. Disconnecttheoatingcablefromthecontrol
box. Replace the protective cap on the control
box.
2. Starting at the cleaner head. Remove all coils
andtanglesfromtheoatingcable(Figure22).
Figure 22. Smooth the Floating Cable
3. Looselycoiltheoatingcablestartingatthe
cleaner and moving toward the connection point
at control box.
Figure 23. Cleaner Correctly Stored on Caddy
13
H0516700_REV A
Bekijk gratis de handleiding van Zodiac Vortex-Pro VX40, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | Vortex-Pro VX40 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4454 MB |
