Handleiding
Je bekijkt pagina 9 van 13

8
❸ Use
3.1 I Presentaon of the regulaon system
Keys
Press and release Press and hold
To conrm a value "On/o"
To browse and adjust values To quickly scroll through the values
Indicator lights
Descripon Steady Flashing O
on
"On/O"
indicator light
Appliance
switched
on
/ Inacve
reg
Heang indicator
lights
Appliance
currently
heang
On hold
Pool at
the desired
temperature
Water ow rate too low (less than 5 m³/h)
Filtraon stopped
Set point temperature greater than pool water
temperature (the indicator ashes for 15
seconds then is lit steadily).
3.2 I Starng the appliance
• Open all valves (V1, V2 and V3) (see §"2.2 I Hydraulic connecons"),
• Start the lter pump,
• Gradually close the by-pass valve (V1),
• Check that the water ow rate is between 5 and 30 m³/h. If the ow rate exceeds 30 m³/h, adjust valve 1
(V1) to reach 30 m³/h maximum,
• Check that there is no air in the circuit,
• Connect the regulaon system to the power supply and turn it on,
• Adjust the set point temperature: to display and change the set point value, press or .
• The temperature is regulated by degrees.
• The set point can be adjusted to between 2°C and 40°C.
• To check that the ltraon me is long enough:
- During the temperature rise phase, water circulaon must be connuous (24 hours/day),
- To maintain the temperature throughout the season, run "automac" circulaon for at least
12 hours/day (the longer this me, the more the operang range of the appliance will suce
for heang).
3.3 I Checks to be carried out aer operang for a few moments
The heater must stop operang when:
• The temperature set point is lowered,
• The regulaon system stops,
• Filtraon stops.
Bekijk gratis de handleiding van Zodiac Red Line, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Zodiac |
Model | Red Line |
Categorie | Heater |
Taal | Nederlands |
Grootte | 3267 MB |