Zodiac K3 handleiding
Handleiding
Je bekijkt pagina 18 van 27
The best battery life is after two or three full charge and
discharge cycles. Although the battery can be recharged
when it is not completely discharged, it is always preferable
to discharge it completely, before charging. The operation
is complete when the LED on the charger turns green. The
device warns of the need to recharge the battery by
emitting three beeps.
Use only original batteries since only these are expressly
designed for the safe use of the equipment. The use of
non-original batteries can cause a decay of the specifica-
tions as well as potential safety risks both during use and
recharging operations.
Observe the following safety regulations when working with
the battery:
• Never put the battery terminals in contact (short circuit)
• Pay particular attention so that accidental short-circuit
situations do not occur due to metal objects, such as
jewelry, coins or keys, which could come into contact with
the battery
• Handle the battery with care, especially if it is charged, in
order to avoid any possible risk
• Under no circumstances throw the battery in fire, they can
explode
• Do not under any circumstances disassemble the battery
Charging Operation
The battery must be charged when the device indicates the
low battery status, emitting three consecutive sounds every
30 seconds. Then use the supplied charger, which is
equipped with a LED, whose colors have the following
meaning:
• Fixed red LED: charging in progress
• Fixed green LED: charging completed
• Flashing red LED: battery overheated or defective
To recharge, proceed as follows, respecting the order of the
subsequent phases:
1 Connect the USB-C type charging cable to the power
supply
2 Connect the other end of the USB-C type cable to the
desktop charger
3 Insert the device, complete with battery, into the charger
4 Connect the power supply to a power socket
5 Make sure that the device with battery is correctly
inserted in the charger: check that the LED light is red
6 Wait for charging to complete (a few hours): when fully
charged, the LED turns green
7 It is possible to recharge the battery only, if disconnected
from the device, by connecting the USB-C type cable
directly to the USB-C socket located on the lower rear
side of the battery, after gently opening the rubber
protection. In this case, the LED on the battery has the
same meaning as the indicator on the desktop charger.
Pay attention to the contacts located on the front of the
BATTERY USEBATTERY USE
• The battery must be disposed of in compliance with the
environmental protection regulations. Refer to the
specific paragraph later in this manual
During charging, the ambient temperature must be betwe-
en 5° C and 40° C; charging outside of these temperatures
may be incomplete. The battery must be recharged with the
device always off; use of the device during charging can
result in incomplete charging. For the same reason, do not
disconnect and reconnect the power supply during rechar-
ging operations.
During use, the battery naturally tends to reduce its capaci-
ty over the long term: if the duration after a complete
charging cycle is excessively reduced, it will be necessary
to replace it.
If the charger indicates full charge, remove the battery from
the charger in a reasonably short time. Leaving the battery
in charge for longer than necessary can result in reduced
performance and life.
battery, in accordance with what is specified in the
previous paragraph.
8 When charging the battery only, make sure that it is
placed on a dry and non-metallic surface, not exposed to
solar radiation and with sufficient ventilation.
9 After charging the battery only, carefully reposition the
rubber protection of the USB-C socket and place the
cable plug back into the socket of the desktop charger.
It is possible that the LED on the charger or on the battery
may remain on for a few moments after removing the
device or cable. This is normal and does not indicate
malfunction.
Bekijk gratis de handleiding van Zodiac K3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | K3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2035 MB |
