Zodiac eXPERT pH handleiding
Handleiding
Je bekijkt pagina 83 van 416
40
7❼ Troubleshoong
• Before you contact the retailer, carry out these few simple checks using the following table if
a problem occurs.
• If the problem is not resolved, contact your retailer.
• : Acons to be performed by a qualied technician only
7.1 I User alerts
Message Possible cause Soluon
• The appliance automacally exits Calibraon
mode aer two minutes without any acon
by the user. This message then appears
briey on the screen.
• Informaon only, no issue.
• If needed, restart the calibraon process from the
beginning, see § “4.4 I Calibrang the sensors (pH or
pH/ORP models)”.
• The value detected during calibraon diers
greatly from the expected value, making
calibraon impossible.
• Visually check the condion of the sensor and rinse
it.
• Repeat the measurement in a buer soluon, wait
15 seconds, then recalibrate if the measurement is
incorrect.
• Clean the sensor or replace if necessary.
• The value detected during calibraon is
unstable, making calibraon impossible.
• The pH pump fuse is faulty.
• Check the pH pump to ensure it’s not damaged.
• Replace the pH pump fuse (inside the chlorinator
power pack).
• The pH pump has stopped.
• pH setpoint has not been reached within allocated
me frame.
• Check pH value and calibrate the pH sensor if
needed.
• Check pH pump tubing and container to ensure pH
minus can be injected.
• Adjust the alarm trigger me, see § “4.3.10. “Pump
stop”: pH pump stop over feed alarm (pH - PH/ORP
models)”.
• Reset the alarm: press
• Steady red: The temperature setpoint is
lower or higher than the measured value
(not blocking)
• Flashing: Water conducvity problem: the
appliance is not reaching 100% producon
• Check the alarm triggering range (see § “4.3 I
Sengs that can be accessed in Conguraon
mode”).
• Check the electrode wiring: ensure compliance with
the numerical codes and the colours (see § “2.1.3.
Connecng the cell to the control box”)
• Check the water temperature.
• Check the condion of the cell plates.
• Measure the salt concentraon in the pool water
using a salt tester or a test strip, then add salt to
the pool to keep the level at 4 or 5 g/L. Consult your
retailer if necessary.
• Steady red: The salt concentraon setpoint
is lower or higher than the measured value
(not blocking)
• Flashing: Water conducvity problem: the
appliance is not reaching 100% producon
• Steady red: The pH setpoint is lower or higher
than the measured value (not blocking)
• Steady red: The ORP setpoint is lower
or higher than the measured value (not
blocking)
• Short-circuit in the cell or cell not properly
connected.
• Worn electrode: the cell is worn out
• Check the cell connecons.
• Replace the cell if necessary: consult your retailer
EN
Bekijk gratis de handleiding van Zodiac eXPERT pH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | eXPERT pH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 146852 MB |
